Derbi Rambla 250 Instruction Manual Page 151

  • Download
  • Add to my manuals
  • Print
  • Page
    / 242
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 150
La manutenzione - Maintenance
Wartung
151
Controllo e pulizia terminali e
morsetti
- Controllare che i terminali «4»dei cavi e i
morsetti «5» dellabatteria siano:
- in buone condizioni (e non corrosi o co perti
da depositi);
- coperti da grasso neutro o vaselina.
Se necessario:
- Scollegare nell’ordine il cavo ne gativo (-) e
quello positivo (+).
- Spazzolare con una spazzola difilo metallico
per eliminare ognitraccia di corrosione.
- Ricollegare nell’ordine il cavopositivo (+) e
quello negativo(-).
- Ricoprire terminali e morsetticon grasso neu-
tro o vaselina.
Ricarica batteria
ATTENZIONE
NON RIMUOVERE I TAPPI DELLA BATTE-
RIA, SE RIMOSSI, LA BATTE RIA POTREB-
BE DANNEGGIARSI.
- Rimuovere la batteria.
- Premunirsi di un adeguato cari ca batteria.
- Predisporre il caricabatteria peruna ricarica
lenta.
- Collegare la batteria al caricabatteria.
Checking and cleaning terminals
and leads
- Check that the terminals «4» ofthe cables
and the battery leads«5» are:
- in good conditions (not corroded or cov ered
by deposits);
- covered by neutral grease or petroleum
jelly.
If necessary:
- Disconnect the negative lead (-)first and then
the positive one(+).
- Brush with a metal bristle brushto eliminate
any sign of corro sion.
- Connect again the positive lead(+) first and
then the negativeone (-).
- Cover the terminals and leadswith neutral
grease or petroleumjelly.
Battery recharge
CAUTION
DO NOT REMOVE THE BATTERY CELL
CAPS OR THE BATTERY MAY BE DAM-
AGED.
- Remove the battery.
- Get an adequate battery charg er.
- Set the battery charger for slowrecharge.
- Connect the battery to the bat tery charger.
-
In gutem Zustand sind (nicht korrodiert oder
mit Ablagerungen bedeckt).
-
mit Neutralfett oder Vaseline bedeckt sind.
Gegebenenfalls:
-
Zuerst das Kabel vom Minuspol (-) und dann
vom Pluspol (+) trennen.
-
Mit einer Bürste oder einem Metalldraht alle
Korrosionsspuren beseitigen.
-
Zuerst das Kabel am Pluspol (+) und dann am
Minuspol (-) anschließen.
-
Die Anschlüsse der Batteriekabel und die
Polklemmen mit Neutralfett oderVaselin
schützen.
Batterieladung
Achtung
DIE BATTERIEVERSCHLÜSSE NICHT
ENTFERNEN. WERDEN DIE BATTERIE -
VERSCHLÜSSE ENTFERNT, KANN DIE
BATTERIE BESCHÄDIGT WERDEN.
-
Die Batterie ausbauen.
-
Ein geeignetes Batterieladegerät vorbereiten.
-
Das Batterieladegerät auf die langsame Ladeart
einstellen.
-
Die Batterie am Batterieladegerät anschließen.
RAMBLA 250 i.e.
Rambla 250 2:Rambla 19/5/08 18:06 Página 151
Page view 150
1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 241 242

Comments to this Manuals

No comments